Dresser pulls – Dresser draws are usually fixed knobs or the pull handles. The secure the front of the box with a screw or two depending on the type of drawing. Over time, the dresser pulls loose due to wear. When drawing becomes loose, it is necessary to make adjustments to tighten the drag to the box. Determination of the dresser draw can be a simple process or may need replacing draw depending on the condition of the screw that holds it in place.
Open the drawer and remove the contents from the box. Press the front of the drawer pull with one hand and tighten the screw on the inside of the box with a Phillips screwdriver. This will usually fix the dresser pulls. Remove the screw with a screwdriver, if it does not pull in the drawer pull. Inspect the screw threads of the screw. The screw is a fine wire and wires often wear down just enough to not pull wires inside.
After that to fix dresser pulls, wrap the screws thread with sewing thread. Start at the bottom of the screw thread and wind the screw threads. Install drawer pull with screw. Replace the drawer pull on pull will still tighten. Replace all drawer pulls on the Agency as the match for the best results.